We have a Dell PowerEdge 840 that had the RAID controller go out yesterday - the system came up with an "ERROR! Adapter Malfunctioning" message.
We replaced the controller with one we had shipped overnight. System was powered off, we made sure the installed was grounded, etc. etc. Upon powering up the system, the following message came up on the display:
===============================
Integrated RAID exception detected:
Volume (00:130) is currently in state INACTIVE/DEGRADED
Enter the SAS Configuration Utility to investigate!
HBA ID LUN VENDOR PRODUCT REVISION CAPACITY
0 LSILogic SAS1067-IR 0.10.49.00 NV 25:0D
Dell Inc. MPT boot ROM, no supported devices found!
...
No boot device available.
===============================
What do I need to do to rebuild the array and see the data? The server apparently crashed shortly after the office closed last Friday but before the backups ran, so we don't have any backed up data from Friday.
Thanks